Normal session join procedure:

1. Power up all devices and allow to boot
2. Prepare content so it is visible on your desired display 
3. Open your course vMix preset
   1. Confirm camera is framed properly and adjust if needed
   2. Confirm audio levels are visible
      1. Look for the blue or green bouncing meter
   3. Minimize vMix
4. Open Zoom and join meeting
   1. Enable audio and video
   2. Confirm video feed to Zoom is present
   3. Test Zoom audio to confirm you are hearing Zoom

Note: Please fill out the blank cells in the tables below with the correct settings for your particular setup. If not certain of the correct settings, please reach out to your Technical Operator for support (Jackson Tinch and Kyle Mabry).

Routing Quick Guide:

If you run into a technical issue live during the session, don't worry about solving the technical issue, just drop to using Zoom. 

Dropping to Zoom Remote:

1. Close vMix and discard changes
2. In Zoom, set the following:

   Device or Feature:	What the correct setting for your setup is:
   Zoom Mic
   Zoom Speaker
   Zoom Camera

3. Share screen for content as with normal Zoom meeting
4. After the session ends, please alert your TO's (Jackson Tinch, Kyle Mabry, Thomas Tekieli) and inform them of the technical issue

Troubleshooting:

1. Double-check audio/video routing in Zoom
2. Exit and relaunch NDI Webcam
3. Reboot and start over
4. Drop to fully remote on Zoom

If Something Breaks

If your camera no longer shows up in NDI Webcam, or you're encountering other issues, we ask that you reach out to the TO's (Jackson Tinch, Kyle Mabry, Thomas Tekieli) and inform them. You can also see our technical operator New User Setup Guide and follow instructions starting at Step 7 and onward.